New Guns In-Stock Guns Accessories Gunsmithing Specials Contact cart
164 Andover St.
Lowell, MA 01852
Voice Line: (978) 452-8450
Voice Line in Massachusetts: (800) 984-4867
Gunsmithing



All custom gunsmithing performed by gunsmith Greg Danas.






A.G. Guns Custom Plating & Gun Refinishing


Hard Chrome or Nickel 

                 Handgun     Longgun     L/G Bbl     D/B Gun     D/B BBl
Matte or Brush   $140        $155        $105        $175        $125
Bright           $160        $175        $125        $195        $145
Bluing 

                 Handgun     Longgun     L/G Bbl     D/B Gun     D/B BBl
Matte or Deluxe  $130        $145        $100        $165        $120
Master           $150        $165        $120        $185        $135
Parkerizing 

Handgun     Longgun     L/G Bbl     D/B Gun     D/B BBl
$125        $140        $105        $185        $135



  • Full Line Gunsmithing
  • Post Season Cleaning Specials
  • Firearm Sight-ins
  • Scope Mounting


    Ruger


    Mark II Pistol
    - Trigger Job: $75



    Glock


    All Glock Firearms
    - Trigger Job: $75



    Colt .45 Government


    Colt .45 Government 1911
    - Trigger Job: $100


    Trigger pulls will vary between 3lbs and 4 1/2 lbs depending on customer request




    Stock Work

    General Stock Alterations
    Parts or bluing not included unless specified
    Install recoil pad $20.00
    Shorten stock and install pad $25.00
    Install standard or Q.D. swivels $20.00
    Glass bed receiver only (average) $30.00
    Glass bed receiver and barrel (average) $45.00

    Stock Refinishing
    Refinish stock unfilled oil $50.00
    Refinish stock filled hand rubbed oil $65.00
    Refinish pistol grips filled oil $20.00
    Recut checkering - done on an hourly basis (average) $45.00
    Repair cracked stock - done on a n hourly basis (no guarantee) (average) $30.00

    Fiberglass Stock Installation
    Stock not included
    Inlet - Glass Bed - Finish & Paint Stock Inquire

     

    Custom Stockwork

    Custom Stock Accessories
    Make and install plain steep grip cap $45.00
    Make and install steel skeleton grip cap $100.00
    Inlet curved butt plate** $40.00
    Inlet skeleton butt plate** $60.00
    Cut stock and refit flat butt plate $18.00
    Cut stock and install curved butt plate** $20.00
    Install trap door butt plates** $45.00

    ** Parts additional